VDC Revit Setup
01
Install plugins
EVOLVE Shop and Fabrication integration require EVOLVE Electrical 10.2.1
EVOLVE Shop Installer
Important Installation Information
EVOLVE Shop integration downloads below require using EVOLVE Electrical 10.2.1, found here.
For the Revit integrations, you must uninstall the previous version prior to updating the new version.
For any Kick 90 that was uploaded from Revit, reupload those bends to ensure the direction of the kick is correct. The previous bends do not have to be deleted, just re-uploaded from Revit.
02
Import data profile (per project)
Import the data profile into each Revit project so parameters and fabrication settings match the shop. Repeat for every project.
Additional resources:
Bend Export Data Profiles
Version 6
Calibration Model
03
Link Revit model to shop project
Link the Revit model to its shop project so spools and fab items sync to the right place.
04
Upload spools/fab items
Upload spools and fabrication items from Revit to the shop project for the prefab team.
01
Install plugins
EVOLVE Shop and Fabrication integration require EVOLVE Electrical 10.2.1
EVOLVE Shop Installer
Important Installation Information
EVOLVE Shop integration downloads below require using EVOLVE Electrical 10.2.1, found here.
For the Revit integrations, you must uninstall the previous version prior to updating the new version.
For any Kick 90 that was uploaded from Revit, reupload those bends to ensure the direction of the kick is correct. The previous bends do not have to be deleted, just re-uploaded from Revit.
02
Import data profile (per project)
Import the data profile into each Revit project so parameters and fabrication settings match the shop. Repeat for every project.
Additional resources:
Bend Export Data Profiles
Version 6
Calibration Model
03
Link Revit model to shop project
Link the Revit model to its shop project so spools and fab items sync to the right place.
04
Upload spools/fab items
Upload spools and fabrication items from Revit to the shop project for the prefab team.
01
Install plugins
EVOLVE Shop and Fabrication integration require EVOLVE Electrical 10.2.1
EVOLVE Shop Installer
Important Installation Information
EVOLVE Shop integration downloads below require using EVOLVE Electrical 10.2.1, found here.
For the Revit integrations, you must uninstall the previous version prior to updating the new version.
For any Kick 90 that was uploaded from Revit, reupload those bends to ensure the direction of the kick is correct. The previous bends do not have to be deleted, just re-uploaded from Revit.
02
Import data profile (per project)
Import the data profile into each Revit project so parameters and fabrication settings match the shop. Repeat for every project.
Additional resources:
Bend Export Data Profiles
Version 6
Calibration Model
03
Link Revit model to shop project
Link the Revit model to its shop project so spools and fab items sync to the right place.
04
Upload spools/fab items
Upload spools and fabrication items from Revit to the shop project for the prefab team.
Additional Downloads
Helpful resources, guides and files — all in one place.
Copyright 2026 EVOLVE MEP. All rights reserved.
Copyright 2026 EVOLVE MEP. All rights reserved.
Copyright 2026 EVOLVE MEP. All rights reserved.